We should comply with the safety regulations required by the factory while operating when we operate the Capes of Noise in causes of noise in vacuum dust collectors.

So, what are the specific operations? It can be divided into the following points:

1. The preparation of the dust collector entered the previous preparation:

For the warehouse that must be entered, the manual adjustment valve of the elevation valve and the air inlet port must be closed to make the warehouse* in an offline state.

All valve mechanical devices are locked in the closed position to prevent accidents from opening. Only after all personnel leave them to turn on. For warehouses that are not allowed to enter, you must manually ask ash twice, and provide enough time to ensure that the ash mitigation system is empty.

Enter a warehouse for maintenance under the working state of the dust collector. First, open the cover, heat dissipation in about two hours, and remove the remaining smoke in the warehouse in a strong ventilation method. When opening the human hole door, you must not stand in front of the door, and there will be high -temperature gas rushing out. To avoid burns.

2. Prevent high -temperature flue gas leakage, scald workers:

Under normal circumstances, in the equipment and pipelines, high -temperature flue gas is in order to prevent leakage and avoid burns and inhale high -temperature gases. Therefore, the person who enters the dust collector must wear the corresponding anti -virus mask or mask. Before entering, it must be confirmed that the smoke inside has been cleared, and it is guaranteed to continue to ventilate. Internal flue gas will be replaced by external air.

3. Prevent high -temperature dust burns:

Generally speaking, the dust inside the dust collector cools for a long time. If it is a pile of dust, the internal temperature is higher, and the high temperature dust may cause burns. When entering the dust collector, you must find that it may fall to enter to enter to enter to enter. Dust of the location, dust may accumulate on the filter bag, flow plate, and wall plate.

4. Steel component burns without cooling:

In the working conditions of the dust collector, the temperature of the steel structures such as the box will be as high as the temperature of the flue gas. The steel structured parts that are not cooling will cause burns. When inspecting the dust collector at work, we must wear protective clothing and gloves. The equipment must be entered after cooling.

causes of noise in vacuum dust collectors https://www.kaisenfilter.com/What-is-the-principle-of-vacuum-dust-collector-and-what-are-the-components.html